Replacing a Chimney Chase Cover in Sparks: Photos and Dimensions First
To replace a chimney chase cover, first document the chase width and depth, every flue location and size, collar heights, edge profile, slope, overhang, attachment, and the condition below the old cover. For a Sparks project, clear roof-level photos and a dimensioned plan let the Reno shop quote the right part without guessing.
Which photos are actually useful?
Take one photo from each side of the chase and one looking down from above when access is safe. Include close views of seams, corners, collars, fasteners, rust, standing water, and any place the old cover has lifted or opened. A wider roof photo should show pitch, nearby walls, and access conditions.
Put a tape measure in selected photos to provide scale, but write dimensions separately too. Photos can distort perspective. If the cover has been removed, photograph the top of the chase, sheathing condition, framing edges, and the way flue components pass through the opening.
What dimensions should go on the sketch?
Measure chase width and depth at the top, then check more than one point. Show the desired overhang on every side and the depth of the turned-down edge. Locate each flue or pipe from two fixed outside edges, and record its outside diameter or dimensions. Don't assume multiple pipes are centered or evenly spaced.
Record collar diameters and heights, the cover's slope or center rise, and any crickets or special drainage shapes. The installer should identify required separation around flue components and confirm that the proposed collars and storm details work with the listed chimney system. Those requirements shouldn't be guessed by the sheet metal shop.
Why not copy the old cover exactly?
An old cover is useful evidence, but it may be bent, rusted, undersized, flat, or poorly attached. Measure the chase and flue layout independently, then decide which existing details should be retained. If water has reached the chase, the contractor should inspect and address damaged material before installing a new cover.
Pro Form Metals fabricates custom chimney caps and related covers at its Reno shop for the nearby Sparks service area. The Sierra Nevada chimney cap guide covers broader material and weather considerations.
Chase-cover field checklist
- Chase width and depth at multiple points
- Flue size and location from two fixed edges
- Required openings and clearances confirmed by installer
- Collar diameter, height, and storm detail
- Cover slope or center rise
- Overhang and turned-down edge profile
- Existing attachment and substrate condition
- Photos from four sides, above, and across the roof
- Material and finish request
- Installer contact and access notes
Send the Reno shop your Sparks chase sketch, roof photos, dimensions, and flue information for review and a fabrication quote.
Frequently asked questions
Can a chase cover be ordered from the old cover's dimensions?
Use the old piece as a reference, not the only source. Verify the chase and every penetration because the old cover may be distorted or may never have fit correctly.
Who confirms the openings around chimney pipes?
The installer or chimney professional should confirm the required opening, separation, collar, and termination details for the specific listed system. The shop fabricates to those confirmed dimensions.
Should damaged sheathing be covered by the new metal?
No. The contractor should evaluate and repair damaged chase materials first. A new cover can shed water when properly detailed, but it isn't a substitute for sound support below it.